If the nock is loose on the nocking point, the arrow changes its impact height

2 studies

ForContextAgainst201220142016201820202022202420262019, context2013, context
Each circle is a study: its position gives the year, its row whether it is for, against or context, its size how many participants it measured. Light circles are studies on other populations or without archers.

Nobody has measured it. The only work that mentions it is the commissioning of a Japanese shooting robot: with a practice bow of about 9 kilograms of draw force, at 18 metres, the same arrow, pulled from the target and shot again ten times, always stayed inside a 160 millimetre circle, but with a vertical spread that the robot alone does not explain. The authors put it down mainly to the nocking point, wider than the nock on a practice bow: the arrow sits in a slightly different place each time, changes its angle and therefore its height on the target. They add that a competition bow, with a tighter nocking point, would by itself remove this part of the spread. It is a reasonable hypothesis, not a measurement: the nocking point was not changed in any test, and the same authors point to a second cause, a draw that varied slightly from shot to shot without a clicker. A machine test from 2013 does at least show that the arrow's height on the string matters a great deal: raised by 10 millimetres, the tear in paper at 2 metres goes from under a millimetre to 40. But a nocking point moved on purpose is not a nock that wobbles, and that test is still missing.

Also phrased as: "loose nock fit"; "nock too loose on the string"; "wide nocking point"; "highs and lows from the nock"

In practice

Archers are told to use a nock that clips onto the string with a slight snap, neither tight nor loose, because a nock that wobbles on the nocking point is said to give highs and lows.

Evidence

  • 2013
    Context Equipment tests Published later

    The author's recurve on a shooting machine, paper test: with the nocking point set where it should be, the tear between point and fletching stays under 1 mm at every distance tried, from 0.8 to 12 m; raising the arrow 10 mm on the string turns it into a 40 mm tear at 2 m, an angle of attack of about 0.06 rad, and the author writes that no archer would accept flight like that. In the model from the same paper the optimum is a gentle minimum: a millimetre of nocking point height changes the arrow's angular velocity by about 8 degrees per second. It measures how much the arrow's position on the string matters, not a nock that wobbles, and it does not look at impact height on the target.

    Arrow behaviour in the vertical plane during and immediately following the power stroke of a recurve bow · James L Park

  • 2019
    Context Equipment tests Published later

    Commissioning a shooting robot with a practice bow of about 9 kgf, at 18 m: the same arrow (809 mm, 7.5 mm diameter, 26.22 g), pulled from the target and shot again ten times, always stays inside a 160 mm circle. The authors put the vertical spread down mainly to a nocking point wider than the nock, which shifts the arrow's position slightly and therefore its angle, and partly to small differences in the draw; the nocking point was not varied, and the spread is shown only in a figure, with no numbers in the text.

    Statics Investigation about Archery Robot in Drawing a Bow · Takuto Nakamura, Yogo Takada, Hitoshi Watanabe

Status history

  1. 2013 Not studied A machine test shows how much the arrow's position on the string matters: with the nocking point raised by 10 mm, the tear in paper at 2 m goes from under a millimetre to 40 mm. It shows that a centimetre in the vertical changes the arrow's launch a great deal, but nobody has yet tried a loose nock or a nocking point with play, or looked at what happens to impact height on the target: the claim has not been studied.
  2. 2019 Not studied Commissioning a shooting robot, with a practice bow at 18 metres, finds a vertical spread that the robot does not explain, and the authors put it down to a nocking point wider than the nock: the arrow sits in a slightly different place each time and changes its angle. It is the first time the question appears in the literature, but as a hypothesis: the nocking point was not changed and the spread has another possible cause as well, a draw that was not always the same. There is no measurement that puts the claim to the test.

Related

Related articles

Research lines

Cite
APA

Campagna, M. (2026). If the nock is loose on the nocking point, the arrow changes its impact height (Version 2). In Evidence Registry. Retrieved 16 October 2026, from https://matteocampagna.com/en/registry/equipment/loose-nock-vertical-spread

BibTeX
@misc{campagna2026_incoccolargodispersioneverticale,
  author = {Campagna, Matteo},
  title = {If the nock is loose on the nocking point, the arrow changes its impact height},
  year = {2026},
  howpublished = {Evidence Registry, matteocampagna.com},
  url = {https://matteocampagna.com/en/registry/equipment/loose-nock-vertical-spread},
  note = {Version 2; accessed 2026-10-16}
}

Other claims in this domain

See all claims on equipment and tuning